Q; Does the 20mm bracelet for a C63 Sealander 39mm fit a C60 Trident Pro 300 40mm, specifically the Atoll.
A; Yes, it fits. Not perfectly, but well enough (95%?) that one would be hard pressed to see the imperfections at a glance.
Labelled photos are self explanatory with points to note;-
Atoll bracelet on Atoll.
1. Tail of the end link is level with the end of the lugs.
2. Top face of end link is flush with the top face of the lugs.
3. Points of the centre section of endlinks are a whisher below the top level of the case.
4. Face of the end link is flush with the side of the case.
Sealander bracelet on Atoll.
1. Tail of the end link is short of the end of the lugs.
2. Top face of the end link is fractionally below the top face of the lugs; more so at the end of the lugs.
3. Points of the centre section of endinks are a noticeably below the top level of the case.
4. There is a small gap between the face of the end link and the side of the case; due to the mismatch in curvature 39mm vs 40mm.
Overall, it's a pretty good fit.
NB> the C60-40-2 and C63-39-2W are SKU codes engraved on the inner face of the endlinks.
Is it acceptable? That's up to the wearer.
Guy
