@sclead - welcome to the forum, Steve.

I don't think I have even seen what you're looking for either.

Whether a gunmetal bracelet will look good on a bronze watch, is entirely up to you; all a matter of personal taste. I've seen black bracelets on steel watches before now, one uses black straps so why not a black bracelet? It's all a matter of aesthetics and beauty is in the eye of the beholder.

It is though also a matter of the technical fit between bracelet end link and case.

In the thread link posted by Steve, above, there was a primary issue that the C60 bracelet will absolutely NOT fit suitably on the C8 case.

For you the question is more subtle. I presume you're looking at the Gunmetal bracelet from the C60 Lympstone fitted to a C60 Pro 300 Bronze.

1. They both have 22mm lugs.
2. They are both 42mm cases.
3. They will probably connect one to the other in a secure manner and without untoward gaps.
BUT
4. As the case is a Pro 300 and the bracelet is Pro 600 the lug dimensions i.e. length and height are different, albeit by fractions of a millimetre, and therefore there will be a slight mismatch between the faces of the end link and lugs.

I did some photos of this a while back to show this difference, albeit on a 40mm case, which I will try to find and post.

Hope this helps.

Guy

This is the thread I referred to in my earlier post that illustrates how well or badly a Pro 300 bracelet fits on a Pro 600 case and vice versa; albeit in 40mm.

I'd expect the results to be similar for the 42mm versions.

OK, it doesn't address the Bronze / Gunmetal issue, but you need to assess the fit first.

Guy

Sent from my Galaxy S23 Ultra using Tapatalk